RATtreks.com - Images of RATventures

Last additions
0917.jpg
1014 viewsFolded it over to make the new edge Mar 11, 2019
0919.jpg
979 viewsHad to drill the slot out so the plastic mounting tab on the trim would fit back in Mar 11, 2019
0915.jpg
981 viewsCut the slits Mar 11, 2019
0914.jpg
977 viewsCut the first section out Mar 11, 2019
0913.jpg
1062 viewsMeasured it to be the same as pass side and taped it Mar 11, 2019
0912.jpg
987 viewscleaned the panel Mar 11, 2019
0911.jpg
955 viewsRemove trim. Mar 11, 2019
0909.jpg
1359 viewsWhile pass side primer was drying I moved to the driver side. This one went much quicker like under an hour now that I had the process down pat. Mar 11, 2019
0901.jpg
1072 viewsPrimed it well. Mar 11, 2019
0900.jpg
1004 viewsI sanded it down and prepped it for primerMar 11, 2019
0899.jpg
988 viewsThe amount of tools needed for this job. Mar 11, 2019
0898.jpg
1025 viewsI custom trimmed the end cap as well so it would fit back on and look like it came that way. Mar 11, 2019
0897.jpg
988 viewsTrim cut to fit and ready to mount Mar 11, 2019
0896.jpg
954 viewsTrimmed the trim piece to fit cutting the door side off so as to keep the part that went around the fender so it would look like it was meant to be there and would still have the mounting screw holes to attach it with. Mar 11, 2019
0895.jpg
1016 viewsPinch weld ground back significantly. Most people beat that over flat or cut it out and weld a flat piece back. Not needed in my case. any larger tire and I would have to. Mar 11, 2019
0892.jpg
1041 viewsAll folded over and also the lower part now cut and folded as well Mar 11, 2019
0893.jpg
988 viewsSide view. I would be grinding back the pinch weld quite a bit too. Mar 11, 2019
0889.jpg
924 viewsFolded over to make the new edge Mar 11, 2019
0888.jpg
982 viewsAnother view of the slits I cut in it. Mar 11, 2019
0887.jpg
980 viewsremoved one piece of tape and cut slits all the way down the piece so it could be folded over to make a nice edge. Not only to eliminate the sharp thin edge but, to make it stronger and to have something to mount the trim piece back to once I cut it down to size. Mar 11, 2019
0886.jpg
972 viewsFirst piece cut out. Mar 11, 2019
0885.jpg
960 viewsCutting the first section out. Mar 11, 2019
0882.jpg
1022 viewsThe first one took me a few hours as I was designing and figuring out how much to cut etc as I went. Taped off the final measurement remembering to leave some to make a folded edge out of. Mar 11, 2019
0880.jpg
992 viewsNow to trim the back of the front fenders. First thing, remove the trim. Mar 11, 2019
13452 files on 561 page(s) 6