
1049 viewsI expected it to rub the lower short arm but it does not. Many use wheel spacers due to that but I will not have to. Mar 11, 2019
|
|

922 viewsA bit close on back of front fender ! Mar 11, 2019
|
|

947 viewsA bit close on front bumper ! Mar 11, 2019
|
|

944 viewsAFTER the lift. Mar 11, 2019
|
|

965 viewsHere you can see how close the front ones are to front bumper Mar 11, 2019
|
|

932 viewshere is height AFTER the lift and rims/tires. Between the 2.5 lift, new isolators and shocks, I managed to get a total of 6 inches of lift. (was 31 inches) Mar 11, 2019
|
|

966 viewsHere you can see how close the front ones are to back of fender Mar 11, 2019
|
|

952 viewsPretty close on rear but should not be a problem, if it is I`ll trim it. Mar 11, 2019
|
|

943 viewsPretty close on rear but should not be a problem, if it is I`ll trim it. Mar 11, 2019
|
|

1049 viewsnew rims /tires mounted Mar 11, 2019
|
|

1046 viewsNew rubber plug replaced and grease topped off. Mar 11, 2019
|
|

1037 viewsRear differential drain plug (if you can call that rubber pos that) leaking so I replaced it with new one and topped off rear end grease as axle grease seals were leaking into the breaks. I will be rebuilding the rear end soon as it has been roaring since I bought it. Mar 11, 2019
|
|

963 viewsOther side all done, not much prying needed there either. Mar 11, 2019
|
|

935 viewsNew Bilstein shock installed Mar 11, 2019
|
|

1005 viewsSway bar re-attached Mar 11, 2019
|
|

1043 viewsYou can see the new rubber isolator at topMar 11, 2019
|
|

1045 viewsSpacer in, now ready to put coil back in. Lots of room on first one. Mar 11, 2019
|
|

918 viewsHere is how much room I was able to get on the first side by jacking the other side up so far, Mar 11, 2019
|
|

1046 viewsJacking up one side as far as it will go to give room to get the coil back in with new rubbers and the spacer. Mar 11, 2019
|
|

1020 viewsPainted with POR Mar 11, 2019
|
|

1095 viewsother rear coil removed Mar 11, 2019
|
|

1006 viewsremoving the lower coil sporing isolator from rear coil . Rusted but nowhere near as bad as front. Cleaned and sanded well and painted with POR. Mar 11, 2019
|
|

946 viewsRubber isolators badly worn back there too Mar 11, 2019
|
|

1027 viewsRemoving rear coils Mar 11, 2019
|
|
| 13452 files on 561 page(s) |
 |
 |
 |
 |
 |
 |
8 |  |
 |
 |
 |
 |
|