722 viewsBumper cover removed.
|
|
799 viewsAll folded over and also the lower part now cut and folded as well
|
|
762 viewsold and new yokes and old and new seals
|
|
740 viewsAFTER painting the trim black ! And a new black grille,,
|
|
760 viewsThe first one took me a few hours as I was designing and figuring out how much to cut etc as I went. Taped off the final measurement remembering to leave some to make a folded edge out of.
|
|
1155 viewsdad's flowers
|
|
705 viewssecondly I trimmed a bit off the back edge of the side of it. I did end up taking a wee bit more than pictured here.
|
|
749 viewsboth driveshafts. The double cardan one came from Iron Rock Offroad
|
|
58505 views
|
|
760 viewsAFTER trimming bumper and fender
|
|
754 viewsHad to drill the slot out so the plastic mounting tab on the trim would fit back in
|
|
735 viewsGrinding the pinch weld back on driver side
|
|
749 viewsTyler in a box canyon at the base of a large waterfall in NC
|
|
811 viewsPainted with POR (since this one on driver side is so bad, I will install a coil spring retainer just for piece of mind)
|
|
1342 views
|
|
865 viewsThe new rims/tires I am going to use after it is lifted
|
|
747 viewsTaping it up to paint the trim black
|
|
767 viewsremoving the lower coil sporing isolator from rear coil . Rusted but nowhere near as bad as front. Cleaned and sanded well and painted with POR.
|
|
817 viewsTyler working to top the tree
|
|
786 viewsnew oil seal installed on transfer case
|
|
1356 viewsSubmitted by Bol'Dar
|
|
767 viewssanded and ready for POR
|
|
789 viewsPainted with POR
|
|
1319 viewsdad's flowers
|
|
| 268 files on 12 page(s) |
 |
|
|
|
|
|
|
9 | |
|
|
