55977 views
|
|
5 viewsAfter the first couple of coats of black trim paint. Plastic trim was in bad shape and had been painted before with a gray that was too light and was a shoddy job it was flaking off so a LOT of sanding had to be done to get it all off and prepped for some good paint done correctly.
|
|
36 viewsSubmitted by Bol'Dar
|
|
9 viewsLower bumper section removed
|
|
24 viewsSubmitted by Bol'Dar
|
|
25 viewsdad's flowers
|
|
9 viewsremoved one piece of tape and cut slits all the way down the piece so it could be folded over to make a nice edge. Not only to eliminate the sharp thin edge but, to make it stronger and to have something to mount the trim piece back to once I cut it down to size.
|
|
8 viewsNo problem getting the first one in
|
|
18 viewsfront yoke of transfer case with yoke and oil seal removed Mar 11, 2019
|
|
12 viewsremoving old lower isolator Mar 11, 2019
|
|
14 viewsAFTER painting the trim black ! And a new black grille,, Mar 11, 2019
|
|
10 viewsnew rims /tires mounted . These are JK take offs and are 255/75.17 so the tires are 32.5 inches tall. Mar 11, 2019
|
|
7 viewsAlso new brake rotors and pads on backMar 11, 2019
|
|
6 viewsAdded some new fluid to the transfer case as well since you lose some when removing the yoke. Mar 11, 2019
|
|
8 viewsNo problem getting the first one in Mar 11, 2019
|
|
10 viewsTo prevent death wobble I installed a new high perf offroad steering damper shock, out with old and in with new. Mar 11, 2019
|
|
12 viewsremoving old lower isolator Aug 18, 2019 at 11:34 AM
|
|
18 viewsfront yoke of transfer case with yoke and oil seal removed Aug 18, 2019 at 11:34 AM
|
|
8 viewsYou can see how well the inner fender worked out in the front and that shiny bolt is where I had to move it forward 2 inches from the black plastic clip you also see in there Jun 09, 2019 at 02:06 PM
|
|
9 viewsI kept trimming until I got the look I was after Jun 09, 2019 at 02:06 PM
|
|
9 viewsLower bumper section removed Jun 09, 2019 at 02:06 PM
|
|
9 viewsTrimmed the back edge as well just like the other side. Jun 09, 2019 at 02:05 PM
|
|
9 viewsNow to cut the driver side bumper cover Jun 09, 2019 at 02:05 PM
|
|
9 viewsWorking out a way to mount the inner fender to the newly trimmed bumper cover so I wouldnt have to cut it as well. It worked out perfect. Jun 09, 2019 at 02:05 PM
|
|
