1057 viewsMeasured it to be the same as pass side and taped it
|
|
971 viewsCut the first section out
|
|
975 viewsCut the slits
|
|
972 viewsHad to drill the slot out so the plastic mounting tab on the trim would fit back in
|
|
1008 viewsFolded it over to make the new edge
|
|
941 viewsMarked the trim for cutting (always go big and then sand it down gradually to get the perfect fit, once its too small you`re screwed !! )
|
|
1125 viewsall slotted and ready for the trim
|
|
1029 viewsYep looks good,
|
|
962 viewsGrinding the pinch weld back on driver side
|
|
1032 viewsCustom fitting the end cap
|
|
1027 viewsEnd cap fitting nicely !
|
|
938 viewsPinch weld ground back a lot
|
|
1004 viewssanded and ready for priming
|
|
932 viewsTaped and primed
|
|
987 viewsinner fender working out well on pass side
|
|
917 viewsComing together nicely happy I could save the inner fender (for now anyway)
|
|
1026 viewsFront part of pass side inner fender looking good after mounting to bumper cover
|
|
1074 viewsDoing away with those crappy factory lug nuts and replacing with Pro Comp off road ones.
|
|
1008 viewsAFTER trimming the fender (I will trim that top part later after I see if I go with a bushwhacker flare OR if I do something custom) For now I have all the clearance i need and it doesnt look that bad but that will get trimmed eventually !!!
|
|
932 viewsAFTER trimming the fender (I will trim that top part later after I see if I go with a bushwhacker flare OR if I do something custom) For now I have all the clearance i need and it doesnt look that bad but that will get trimmed eventually !!!
|
|
965 viewsAFTER trimming bumper and fender
|
|
972 viewsFront after trimming
|
|
967 viewsDriver side inner fender remounted
|
|
925 viewsDriver side inner fender mounted
|
|
|
|
