963 viewsFirst piece cut out. Nov 14, 2026 at 06:48 PM
|
|
1014 viewsTyler removing a black snake we found while taking a large Maple tree down. Nov 14, 2026 at 06:48 PM
|
|
1307 viewsdad's flowersNov 14, 2026 at 06:48 PM
|
|
1372 viewsdad's flowersNov 14, 2026 at 06:48 PM
|
|
1006 viewsPinch weld ground back significantly. Most people beat that over flat or cut it out and weld a flat piece back. Not needed in my case. any larger tire and I would have to. Nov 14, 2026 at 06:47 PM
|
|
925 viewsNo problem getting the first one in Nov 14, 2026 at 06:47 PM
|
|
1042 viewsI expected it to rub the lower short arm but it does not. Many use wheel spacers due to that but I will not have to. Nov 14, 2026 at 06:47 PM
|
|
1038 viewsJacking up one side as far as it will go to give room to get the coil back in with new rubbers and the spacer. Nov 14, 2026 at 06:47 PM
|
|
1018 viewsI custom trimmed the end cap as well so it would fit back on and look like it came that way. Nov 14, 2026 at 06:47 PM
|
|
1074 viewsDoing away with those crappy factory lug nuts and replacing with Pro Comp off road ones. Nov 14, 2026 at 06:47 PM
|
|
997 viewsFirst I cut out a large slot in the lower end of the bumper cover Nov 14, 2026 at 06:46 PM
|
|
983 viewsThe amount of tools needed for this job. Nov 14, 2026 at 06:46 PM
|
|
1090 viewsother rear coil removed Nov 14, 2026 at 06:46 PM
|
|
1002 viewsBadly worn and dry rotted rubber isolators and rusted frame towers Nov 14, 2026 at 06:46 PM
|
|
1263 viewsNov 14, 2026 at 06:46 PM
|
|
939 viewsPretty close on rear but should not be a problem, if it is I`ll trim it. Nov 14, 2026 at 06:44 PM
|
|
2556 viewsHUGE Oak tree that fell and almost crushed our neighbors house. Tyler and I removed it for them. Nov 14, 2026 at 06:43 PM
|
|
975 viewsremoved one piece of tape and cut slits all the way down the piece so it could be folded over to make a nice edge. Not only to eliminate the sharp thin edge but, to make it stronger and to have something to mount the trim piece back to once I cut it down to size. Nov 14, 2026 at 06:42 PM
|
|
971 viewshorn wires in the wayNov 14, 2026 at 06:40 PM
|
|
1125 viewsall slotted and ready for the trim Nov 14, 2026 at 06:40 PM
|
|
924 viewshere is height AFTER the lift and rims/tires. Between the 2.5 lift, new isolators and shocks, I managed to get a total of 6 inches of lift. (was 31 inches) Nov 14, 2026 at 06:40 PM
|
|
1484 viewsSubmitted by Bol'DarNov 14, 2026 at 06:40 PM
|
|
984 viewsTyler helping to bust through the sidewalk so we can remove the old clay gutter drain pipe. Nov 14, 2026 at 06:39 PM
|
|
1037 viewsYou can see the new rubber isolator at topNov 14, 2026 at 06:39 PM
|
|
| 268 files on 12 page(s) |
2 |  |
|
|
|
|
|
|
|
|
|
