 |
Last additions - 1999 Jeep WJ pics |
 |
|
996 viewsNew isolators and spacer installed Mar 11, 2019
|
|
979 viewsNew isolators and spacer installed Mar 11, 2019
|
|
1265 viewsNew isolators and spacer installed Mar 11, 2019
|
|
1039 viewsone rear coil done Mar 11, 2019
|
|
1021 viewsPainted with POR (since this one on driver side is so bad, I will install a coil spring retainer just for piece of mind) Mar 11, 2019
|
|
947 viewsPainted with PORMar 11, 2019
|
|
1011 viewsHad to clean all this up and sand it good and painted with rust inhibitor (POR) Mar 11, 2019
|
|
1069 viewsBadly worn and dry rotted rubber isolators and rusted frame towers Mar 11, 2019
|
|
1142 viewsMar 11, 2019
|
|
996 viewsBadly worn and dry rotted rubber isolators and rusted frame towers Mar 11, 2019
|
|
995 viewsThe coil spring towers were extremely rusted out. I did not both with replacing these as I am not planning on doing hardcore off roading otherwise I would have cut those off and welded in a repair kit or fabricated something. Mar 11, 2019
|
|
1056 viewsremoving the front coil springs Mar 11, 2019
|
|
1053 viewsThe new rims/tires I am going to use after it is lifted Mar 11, 2019
|
|
1008 viewsFactory setup Mar 11, 2019
|
|
1016 viewsFactory height (actually a little under due to deteriorated coil spring isolators which are also being replaced) Mar 11, 2019
|
|
1008 views1999 Jeep Grand Cherokee Laredo / 4.0L BEFORE installing a 2.5 inch spacer lift kit from Supreme Suspensions, Bilstein shocks, and a front driveshaft conversion from Rzeppa/Rzeppa type (CV) to a Double Cardan type (U Joint) . Mar 11, 2019
|
|
|
|
