968 viewsAFTER trimming bumper and fender Mar 11, 2019
|
|
935 viewsAFTER trimming the fender (I will trim that top part later after I see if I go with a bushwhacker flare OR if I do something custom) For now I have all the clearance i need and it doesnt look that bad but that will get trimmed eventually !!! Mar 11, 2019
|
|
1009 viewsAFTER trimming the fender (I will trim that top part later after I see if I go with a bushwhacker flare OR if I do something custom) For now I have all the clearance i need and it doesnt look that bad but that will get trimmed eventually !!! Mar 11, 2019
|
|
1076 viewsDoing away with those crappy factory lug nuts and replacing with Pro Comp off road ones. Mar 11, 2019
|
|
1027 viewsFront part of pass side inner fender looking good after mounting to bumper coverMar 11, 2019
|
|
920 viewsComing together nicely happy I could save the inner fender (for now anyway) Mar 11, 2019
|
|
988 viewsinner fender working out well on pass side Mar 11, 2019
|
|
935 viewsTaped and primed Mar 11, 2019
|
|
1005 viewssanded and ready for priming Mar 11, 2019
|
|
940 viewsPinch weld ground back a lot Mar 11, 2019
|
|
1028 viewsEnd cap fitting nicely ! Mar 11, 2019
|
|
1032 viewsCustom fitting the end cap Mar 11, 2019
|
|
963 viewsGrinding the pinch weld back on driver side Mar 11, 2019
|
|
1031 viewsYep looks good, Mar 11, 2019
|
|
1127 viewsall slotted and ready for the trim Mar 11, 2019
|
|
943 viewsMarked the trim for cutting (always go big and then sand it down gradually to get the perfect fit, once its too small you`re screwed !! ) Mar 11, 2019
|
|
1008 viewsFolded it over to make the new edge Mar 11, 2019
|
|
973 viewsHad to drill the slot out so the plastic mounting tab on the trim would fit back in Mar 11, 2019
|
|
976 viewsCut the slits Mar 11, 2019
|
|
972 viewsCut the first section out Mar 11, 2019
|
|
1059 viewsMeasured it to be the same as pass side and taped it Mar 11, 2019
|
|
981 viewscleaned the panel Mar 11, 2019
|
|
949 viewsRemove trim. Mar 11, 2019
|
|
1355 viewsWhile pass side primer was drying I moved to the driver side. This one went much quicker like under an hour now that I had the process down pat. Mar 11, 2019
|
|
| 268 files on 12 page(s) |
 |
|
|
5 | |
|
|
|
|
|
|
