1069 viewsPrimed it well. Mar 11, 2019
|
|
1000 viewsI sanded it down and prepped it for primerMar 11, 2019
|
|
986 viewsThe amount of tools needed for this job. Mar 11, 2019
|
|
1020 viewsI custom trimmed the end cap as well so it would fit back on and look like it came that way. Mar 11, 2019
|
|
985 viewsTrim cut to fit and ready to mount Mar 11, 2019
|
|
950 viewsTrimmed the trim piece to fit cutting the door side off so as to keep the part that went around the fender so it would look like it was meant to be there and would still have the mounting screw holes to attach it with. Mar 11, 2019
|
|
1010 viewsPinch weld ground back significantly. Most people beat that over flat or cut it out and weld a flat piece back. Not needed in my case. any larger tire and I would have to. Mar 11, 2019
|
|
1038 viewsAll folded over and also the lower part now cut and folded as well Mar 11, 2019
|
|
984 viewsSide view. I would be grinding back the pinch weld quite a bit too. Mar 11, 2019
|
|
922 viewsFolded over to make the new edge Mar 11, 2019
|
|
978 viewsAnother view of the slits I cut in it. Mar 11, 2019
|
|
977 viewsremoved one piece of tape and cut slits all the way down the piece so it could be folded over to make a nice edge. Not only to eliminate the sharp thin edge but, to make it stronger and to have something to mount the trim piece back to once I cut it down to size. Mar 11, 2019
|
|
966 viewsFirst piece cut out. Mar 11, 2019
|
|
956 viewsCutting the first section out. Mar 11, 2019
|
|
1016 viewsThe first one took me a few hours as I was designing and figuring out how much to cut etc as I went. Taped off the final measurement remembering to leave some to make a folded edge out of. Mar 11, 2019
|
|
988 viewsNow to trim the back of the front fenders. First thing, remove the trim. Mar 11, 2019
|
|
1025 viewsFront bumper lower part trimmed Mar 11, 2019
|
|
994 viewsPass side trimmed Mar 11, 2019
|
|
1089 viewsDriver side trimmed Mar 11, 2019
|
|
995 viewsnew blots to mount the bottom of the bumper cover. There are 4 down there and this one was missing almost all. Mar 11, 2019
|
|
1018 viewsI reused the cut pieces and riveted them back to the trimmed bumper corners so I would have a nice edge instead of a narrow cut one and a way to mount the inner fenders back to it. I would epoxy glue those later in this process for stability as those rivets would never last by themselves under off roading conditions. Mar 11, 2019
|
|
996 viewsYou can see how well the inner fender worked out in the front and that shiny bolt is where I had to move it forward 2 inches from the black plastic clip you also see in there Mar 11, 2019
|
|
1049 viewsI kept trimming until I got the look I was after Mar 11, 2019
|
|
1023 viewsLower bumper section removed Mar 11, 2019
|
|
| 268 files on 12 page(s) |
 |
|
|
|
6 | |
|
|
|
|
|
