 |
Most viewed - 1999 Jeep WJ pics |
 |
|
994 viewsSway bar re-attached
|
|
992 viewsFirst I cut out a large slot in the lower end of the bumper cover
|
|
990 viewsNow to cut the driver side bumper cover
|
|
989 viewsI sanded it down and prepped it for primer
|
|
986 viewsnew blots to mount the bottom of the bumper cover. There are 4 down there and this one was missing almost all.
|
|
985 viewsPass side trimmed
|
|
983 viewsYou can see how well the inner fender worked out in the front and that shiny bolt is where I had to move it forward 2 inches from the black plastic clip you also see in there
|
|
981 viewsinner fender working out well on pass side
|
|
979 viewsNew isolators and spacer installed
|
|
979 viewsAfter a couple of coats of good black trim paint WITH flex additive
|
|
979 viewsAFTER painting the trim black ! And a new black grille,,
|
|
979 viewsThese are the rims/tires I am wishing to put on after the lift
|
|
978 viewsNow to trim the back of the front fenders. First thing, remove the trim.
|
|
977 viewsAFTER !
|
|
976 viewsAFTER !
|
|
975 viewsFront diff = old oil seal after yoke removed
|
|
975 viewsTaping it up to paint the trim black
|
|
975 viewsremoving old lower isolator
|
|
974 viewsThe amount of tools needed for this job.
|
|
973 viewsAdded some new fluid to the transfer case as well since you lose some when removing the yoke.
|
|
972 viewsSide view. I would be grinding back the pinch weld quite a bit too.
|
|
971 viewsNow I replaced the plastic bumper cover so I cut start cutting it.
|
|
971 viewsAFTER !!
|
|
971 viewssanded and ready for POR
|
|
|
|
