 |
Most viewed - 1999 Jeep WJ pics |
 |
|
952 viewsTaping it up to paint the trim black
|
|
951 viewsAFTER painting the trim black ! And a new black grille,,
|
|
949 viewsHere you can see how close the front ones are to back of fender
|
|
948 viewsAFTER painting the trim black ! And a new black grille,,
|
|
946 viewsCoil spring retainer installed on driver side (remember that tower was rusted nearly gone ??) Just one less thing to worry about when going down the trail !!
|
|
945 viewsPainted with POR
|
|
945 viewsCutting the first section out.
|
|
942 viewsboth driveshafts. The double cardan one came from Iron Rock Offroad
|
|
941 viewsAlso new brake rotors and pads on back
|
|
936 viewsPretty close on rear but should not be a problem, if it is I`ll trim it.
|
|
935 viewsRubber isolators badly worn back there too
|
|
935 viewsEpoxy applied to the driver side corner piece I made and riveted on
|
|
935 viewsepoxy glue on pass side
|
|
932 viewsAFTER the lift.
|
|
932 viewsTrimmed the trim piece to fit cutting the door side off so as to keep the part that went around the fender so it would look like it was meant to be there and would still have the mounting screw holes to attach it with.
|
|
932 viewsRemove trim.
|
|
931 viewsPinch weld ground back a lot
|
|
930 viewsBumper cover removed.
|
|
930 viewsMarked the trim for cutting (always go big and then sand it down gradually to get the perfect fit, once its too small you`re screwed !! )
|
|
929 viewsPretty close on rear but should not be a problem, if it is I`ll trim it.
|
|
928 viewsA bit close on front bumper !
|
|
927 viewsTaped and primed
|
|
926 viewsAFTER trimming the fender (I will trim that top part later after I see if I go with a bushwhacker flare OR if I do something custom) For now I have all the clearance i need and it doesnt look that bad but that will get trimmed eventually !!!
|
|
925 viewsNew Bilstein shock installed
|
|
|
|
