 |
Most viewed - 1999 Jeep WJ pics |
 |
|
922 viewsPass side. That piece of metal is usually completely removed on these type of jobs but, I decided not to. I cut it and bent it over where the two horns are. I had to modify the horns position so that the wires came down from top instead of sticking out the back which worked well.
|
|
921 viewsDriver side inner fender mounted
|
|
921 viewsAFTER painting the trim black ! And a new black grille,,
|
|
919 viewshere is height AFTER the lift and rims/tires. Between the 2.5 lift, new isolators and shocks, I managed to get a total of 6 inches of lift. (was 31 inches)
|
|
919 viewsAFTER painting the trim black ! And a new black grille,,
|
|
918 viewsNo problem getting the first one in
|
|
917 viewsMetal cut and bent, horn wires relocated I am going to save the inner fenders too. (something else most people do away with when doing this)
|
|
916 viewsFolded over to make the new edge
|
|
916 viewsnew yoke installed on front diff
|
|
912 viewsTaping it up to paint the trim black
|
|
911 viewsComing together nicely happy I could save the inner fender (for now anyway)
|
|
909 viewsA bit close on back of front fender !
|
|
905 viewsHere is how much room I was able to get on the first side by jacking the other side up so far,
|
|
891 viewsfront yoke of transfer case with yoke and oil seal removed
|
|
861 viewscleaned and ready for POR
|
|
847 viewshere you can see just how high I jacked it up to eliminate so much prying and straining !
|
|
|
|
