31 viewsNew front driveshaft done
|
|
31 viewsremoving the lower coil sporing isolator from rear coil . Rusted but nowhere near as bad as front. Cleaned and sanded well and painted with POR.
|
|
31 viewshere is height AFTER the lift and rims/tires. Between the 2.5 lift, new isolators and shocks, I managed to get a total of 6 inches of lift. (was 31 inches)
|
|
30 viewsdriveshaft mounted to front diff
|
|
30 viewsNow moving to the rear
|
|
30 viewsRemoving rear coils
|
|
30 viewsRubber isolators badly worn back there too
|
|
30 viewsA bit close on front bumper !
|
|
29 viewsPainted with POR
|
|
29 viewsNew Bilstein shock installed
|
|
28 viewsSubmitted by Bol'Dar
|
|
28 viewsdad's flowers
|
|
28 viewsdad's flowers
|
|
28 viewsWildflowers along AT on Elk River
|
|
28 viewsHere is how much room I was able to get on the first side by jacking the other side up so far,
|
|
28 viewsSpacer in, now ready to put coil back in. Lots of room on first one.
|
|
28 viewsYou can see the new rubber isolator at top
|
|
28 viewsRear differential drain plug (if you can call that rubber pos that) leaking so I replaced it with new one and topped off rear end grease as axle grease seals were leaking into the breaks. I will be rebuilding the rear end soon as it has been roaring since I bought it.
|
|
27 viewsSubmitted by Bol'Dar
|
|
27 viewsdad's flowers
|
|
27 viewsWildflowers along AT on Elk River
|
|
27 viewsother rear coil removed
|
|
27 viewsHere you can see how close the front ones are to front bumper
|
|
27 viewsAFTER painting the trim black ! And a new black grille,,
|
|
266 files on 12 page(s) |
|
|
4 | |
|
|
|
|
|
|
|